Introduction; Intended Use - Viatom Checkme O2 Benutzerhandbuch

1

Introduction

1.1

Intended Use

This product is intended to be used for measuring, displaying and storing
of pulse oxygen saturation (SpO
healthcare facilities environment.
Note:
The data and results provided by this device are for pre-check

screening purpose only and cannot be directly used for diagnostic or
treatment.
The data provided by the APP and PC software is not intended for

diagnosis or treatment purpose, always consult your doctor for any
health condition.
Warnings and Cautionary Advice
DO NOT squeeze the sensor or apply excessive force on the

sensor & cable.
Do not use this device during MRI examination.

Never submerge the device in water or other liquids. Do not

clean the device with acetone or other volatile solutions.
Do not place this device in pressure vessels or gas sterilization

device.
Consult your doctor immediately if you experience symptoms

that could indicate acute disease.
Do not self-diagnose or self-medicate on the basis of this device

without consulting your doctor. In particular, do not start taking
) , pulse rate and motion in home or
2
2