Renson Healthbox II TouchDisplay Bedienungsanleitung Seite 65

➋
➌
Remarks on programming the secondary control
• The CO threshold needs to be deactivated on the secondary control.
2
(see section 9: 'setting the CO
• When a control is programmed as secondary control, it is no longer possible to configure
any program points on this control.
• No program point is displayed on the secondary control when the main modes
(ECO – HDC – NIGHT) are activated. There is no visible difference when the secondary
modes (BOOST – EMPTY HOUSE – KITCHEMODE) are activated.
• Errors are not displayed on the secondary control.
• Select "main controller" with
• By using or
▲ ▼
control (= Main Controller: OFF). Confirm by pressing
You will return into the INSTALLER MENU – DEVICE SETTINGS.
• Press shortly on both
To then exit the USER MENU as well, again press both
▲ and ▼ .
Threshold')
2
n .
you can set the TouchDisplay as secondary
▲ and ▼ to exit the INSTALLER MENU.
n .
EN
65