Renson Healthbox II TouchDisplay Bedienungsanleitung Seite 41

• Exposure to radio waves.
The TouchDisplay contains a radio transmitter and receiver.
When activated, the TouchDisplay transmits and receives radio waves through the antenna.
• Do not install the TouchDisplay in rooms where it can be exposed to the following conditions:
­ A greasy atmosphere
­ Corrosive or flammable gasses, fluids or vapours
­ Room temperatures above 40°C or lower than ­5°C.
­ Relative humidity higher than 90%
­ Areas where it could be exposed to water
Never submerge the TouchDisplay in water.
• Always take the following safety regulations into consideration when installing the
TouchDisplay. Non­compliance can result in damaging the appliance or in personal injury.
RENSON cannot be held accountable in such situations.
®
­ Make sure that the electric power supply is 230V, 1 phase, 50Hz.
­ The installation has to be performed in accordance with the general and local construction
safety and installation regulations.
­ The appliance needs to be installed in a way that prevents accidental contact. This means
that under normal circumstances nobody should be able to come in contact with
components under tension.
EN
41