roco zimo Betriebsanleitung Seite 10

Possible Settings in Motorola**
Before using the Sounddecoder in Motorola**
digital operation the dip switches 1 and 2 at the
back of the Märklin* 6021 base station must be
set to "ON". In order to ensure that this change-
over is effective, the base station must be reset
(press the "Stop" and "Go" keys simultaneously
until the display goes out and "99" appears
briefly, then press "Stop" separately and "Go"
again). An additional direction arrow in the dis-
play indicates that operation is currently in the
Motorola** new format required here.
For the Intellibox the address used must also be
specified in the "Motorola** new format" for
the sound operation of the decoder.
The Registers correspondent with the CV's
GB
For the preset factory values please see the informa-
tion sheet enclosed with the locomotive or decoder.
For programming the Motorola** Register
• the drive controller should be set to "0"
• remove all locomotives from the layout except
those you wish to program or place the locomo-
tive to be programmed on the Intellibox pro-
gramming track (the addresses must be set to
the Motorola** new format on the Intellibox;
programming takes place in accordance with the
Intellibox instructions for DCC decoders.
• Please observe the flashing of the lights during
programming.
Märklin*6021
1 Trigger a reset (press "Stop" and "Go" simulta-
neously for a few seconds).
2 Switch off power to rails ("Stop")
3 Enter two-digit locomotive address or "80"
4 Press travel direction selector, keep depressed
and also press "Go":
The decoder is in the programming mode and is
waiting for the register number to be entered:
short flash
5 Enter two-digit register number (CV).
6 Press travel direction selector:
The decoder is waiting for a value to be entered:
combination of long/short tones in quick succes-
sion.
7 Enter two-digit value.
8 Press travel direction selector:
The decoder first confirms the value has been
entered with a long
flashing at long intervals as it waits for a new
register number to be re-entered.
9 Either reprogram the desired next register with
steps No. 5 to 8 or enter "80" for the end of
programming.
10 Press travel direction selector
Please note that the Märklin* 6021 only allows you
to enter the values 01 to 79. The value 0 does not
appear. Instead of „00" the value „80" must be
entered instead.
10
Digital Operation
at long intervals.
short double flashing at long intervals.
glow This is followed by shor