VEVOR RCH-6050 Bedienungsanleitung Seite 6

7. If a few hydraulic cylinders raise the load at the same time, in addition to the
accurate configuration of hydraulic cylinders, multiple redundant hydraulic
cylinders should be used, the load of each set of hydraulic cylinders should be
balanced, and attention should be paid to maintaining a synchronous rising speed
when starting. Also, pay attention to the possible subsidence of heavy objects on
the bottom to prevent the danger of heavy objects leaning to one side.
8. When in use, first select the contact position of the load and the top of the
hydraulic cylinder, and then tighten the oil release bolt on the pump, the hydraulic
cylinder can work immediately, to make the piston rod fall, to avoid the pressure
relief speed too fast to cause danger.
9. This jack fastens the spring coil to reset the structure and raises heavy load over
after; it can immediately quickly take out but can not pull the jack with the copular
soft tube.
10. As the jack rises again, the distance is smaller, and the user never exceeds a
sum while using the settle route of travel so as not to damage the hydraulic
cylinder.
11. Use the process to avoid the hydraulic cylinder vibration.
12. Not suitable for use in workplaces with acidic, corrosive air.
13. The user has to periodically check and maintain according to the circumstance.
REGULATION
1. During operation, if the manual pump appears empty Angle, you can loosen the
oil drain bolt on the pump body, pump the pump body in the vertical upward state
several times, and then tighten the oil drain bolt; you can continue to use it.
2. When using, can not add to be partial to carry or overload, so as hot to the jack
breaks occurrence danger. While having already carried a lotus, slicing to hate will
quickly deal with contact to unload so as not to cause trouble and damage spare
parts.
3. To ensure the quality of this product, the hydraulic cylinder must be regularly
maintained to avoid overflow or oil leakage when the machine is working, affecting
the use of the effect.
4. New or long-vacant hydraulic cylinder: because of the oil urn, the memory
contains more air, and the piston pole may appear to a slight jump while starting to
use; you can operate the hydraulic cylinder with no load down and back movement
2-3 times to discharge the air in the chamber.
5