RAPTURE SPECTER Bedienungsanleitung Seite 9

• BT2 (the switch is in the lower position, the LED lights red after
briefly pressing the pairing button).
It takes about 2–4 seconds for the mouse to switch modes.
Sensitivity setting
Adjust the mouse sensor sensitivity by repeatedly pressing the DPI but-
ton at the upper part of the mouse. The default sensitivity is 1200 DPI.
You can set the sensitivity from 800 to 8000 DPI:
• 800 DPI: the LED indicator will glow red;
• 1200 DPI: the LED indicator will glow green;
• 1600 DPI: the LED indicator will glow blue;
• 2400 DPI: the LED indicator will glow cyan;
• 3200 DPI: the LED indicator will glow yellow;
• 8000 DPI: the LED indicator will glow purple.
Note: Sensor sensitivity can also be adjusted via software installed on
your computer. Here you can set the sensitivity up to 16000 DPI.
Software
You can download the advanced mouse setup software using the QR
code provided below.
CLEANING
Keep the mouse clean. Before cleaning, disconnect the mouse from your
computer if it is connected by cable.
Use only a dry, clean cloth for cleaning. Do not use harsh cleaners, sol-
vents, gasoline or other similar substances. Never wash the mouse with
water and do not immerse it in water.
9