RAPTURE SPECTER Bedienungsanleitung Seite 7

INSTRUCTIONS
Mouse Power On / Off
The mouse will automatically turn on when connected to a device.
The mouse will automatically switch to sleep mode after 1 minute of
inactivity. Move the mouse or press any button to turn it on again.
The mouse switches to deep sleep mode after 5 minutes of inactivity.
Press any button to switch it on again.
Charging the mouse
The mouse must be charged before first use. The mouse can be charged
in any switch position, i.e. 2.4 G, wired and BT (top to bottom).
Plug the USB-C end of the cable into the USB-C socket on the mouse,
then plug the USB-A end of the cable into the USB-A port on your com-
puter. The DPI LED status light will glow red. When the DPI LED status
light glows green, the mouse is charged.
If the DPI LED status light starts flashing red during use, charge the
mouse.
When not using the mouse, we still recommend charging it regularly – at
least once every three months. This will extend the life of the built-in
battery.
Mouse Connection – USB Receiver
1. Move the mode switch at the bottom of the mouse to the "2.4G"
(top) position. The LED will flash green several times and then go
out.
2. Plug the USB receiver into your computer/laptop. The system will
automatically install the drivers and make the mouse ready for use.
The LED lights up green and then goes out.
Note: The mouse and USB receiver are paired at the factory. If for some
reason unpairing should occur, make sure the mode switch at the bottom
of the mouse is in the "2.4G" (top) position, and press and hold the
pairing button (#7 in the picture) for at least 3 seconds. The LED flashes
green and then goes out.
Note: The maximum range between the mouse and the USB receiver is
10 m, but to account for environmental effects and possible interfer-
ence, we recommend a distance of no more than 2 m. When using the
7