RAPTURE SPECTER Bedienungsanleitung Seite 8

mouse in a high-interference environment, we recommend a distance of
no more than 20 cm.
Mouse Bluetooth connection
The mouse can be connected via Bluetooth to two devices. Each
connection is indicated by a different colour of the LED.
1. Move the mode switch at the bottom of the mouse to the "BT"
(bottom) position. The LED will slowly flash blue.
2. Press and hold the pairing button (#7 in the picture) for 3 seconds
until the LED flashes rapidly in blue (BT1) or red (BT2).
3. Turn on Bluetooth on your computer and start searching for devices.
4. Click to select the mouse labelled "SPECTERBT1" or
"SPECTERBT2" to pair the mouse with the computer.
5. When the mouse is successfully paired with the device, the LED will
glow in the respective colour for approximately 5 seconds.
Switching between Bluetooth connections
1. Move the mode switch at the bottom of the mouse to the "BT"
(bottom) position.
2. By pressing the pairing button (#7 in the picture) briefly, you
can switch between BT1 and BT2. The LED will always turn the
appropriate colour (blue for BT1 or red for BT2).
Wired Connection
Move the mode switch at the bottom of the mouse to the middle position.
Plug the USB-C end of the cable into the USB-C socket on the mouse,
then plug the USB-A end of the cable into the USB-A port on your
computer. The system will automatically install the drivers and make the
mouse ready for use.
Mode selection
If the mouse is connected to different devices, move the slider to select
operating mode:
• 2.4 GHz (the switch is in the upper position);
• Wire connection (switch is in the middle position);
• BT1 (the switch is in the lower position, the LED lights blue after
briefly pressing the pairing button);
8