Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecti o n & Control
TO CONTROL THE CAMERA USING RS-485 DEVICE
VIA COAXIAL COMMUNICATIONS
1.
Connect the product to DC 12V power source or insert 4 AA-sized
batteries into the battery compartment.
2.
Set the protocol switch 7 to ON.
3.
Connect the VIDEO IN of the unit and VIDEO OUT of the AI Camera
directly.
–
For proper data communication, the unit and AI camera should be connected directly.
(If you connect a DVR or keyboard in the middle of the main unit and AI camera,
bidirectional communication will not be established.)
4.
Connect VIDEO OUT of the main unit to a monitor's video input terminal.
5.
Connect TX(+/-) of RS-485 device to RX(+/-) of the main unit.
(For a full duplex system, connect RX(+/-) of RS-485 device to TX (+/-) of
main unit additionally.)
6.
Using RS-485 device, you can control the camera menu.
–
For proper coaxial communication, AI camera should be set to Samsung protocol.
Refer to the switch settings. (See page 17)
By factory default, protocols of SAMSUNG and PANASONIC are supported.
NOTE
For additional protocols, update the following software program via the web.
Input of video signal is required to control RS-485.
English 13
Werbung
Kapitel
Inhaltsverzeichnis
