Configuration Setting - Panasonic Rf-D40 Bedienungsanleitung

Configuration setting

1. Press [MENU].
2. Press [ ]/[ ] repeatedly to select "Configuration".
3. Press [OK] to view configuration menu.
4. Press [VOL+]/[VOL-] to select an item or option.
5. Press [OK] to confirm.
Device
Equaliser
Network
Dimmer
3 4 4
3
Alarm
Power
Management
Sleep Timer
Date&Time
3
3
Time Display
Local Radio Setup
FM Setup
Playback Setup
Language
Resume When
Power On
Software Update
Reset to Default
body改箭头.indd 12
• Rename: Change the unit displayed name.
• System Information: View the system information.
You can select the equaliser mode (Normal, Pop, Flat, Classical).
• Wireless Network Configuration: Select to connect or disconnect with the
network.
• Keep network connected: Select to set the unit to connect or disconnect
with the network in standby mode.
Set the brightness of the display in standby mode and operation mode. Press
[ ]/[ ] to decrease or increase the brightness.
5 5
• Alarm1&2: You can set two timers by setting the repeat day, time and sound
source.
• NAP Alarm: You can set a countdown timer.
• Alarm Volume: Set the maximum volume of the timer.
Stop the alarm
Press [ ] to stop alarm sound.
Snooze function
Press [OK] on the remote control or [-VOLUME+/SCAN/SELECT] on the unit to
put the alarm into snooze mode. Press [
The unit will enter standby mode after the set time of inactivity. Select "Turn Off"
to cancel.
The timer switches off the unit after the set time (in minutes). Select "Turn Off" to
cancel.
4 4 5
Set the date/time and date/time format.
Set the color of the time displayed during standby mode.
Set the region of the local radio mode.
Set "FM mode" and "FM Sensitivity" for better reception.
Set the playback mode in USB mode.
You can select the language for the display panel.
• ON: The previously played function is resumed when the unit is switched on
from the standby mode.
• Off: Cancel the setting. The main menu is displayed when the unit is
switched on.
Select to update the available software.
DO NOT DISCONNECT the AC mains lead while updating the software.
Select "Yes" to reset the unit to factory default setting.
6 7
6 7
] to stop snooze mode.
5
6 6
12
7 7
2024/11/21 8:34:37