Timago ELITE-TIM Benutzerhandbuch Seite 32

wheelchair can also be pushed by an accompanying person. The wheelchair is
suitable for indoor and outdoor use.
3. Assembly
Step 1. Unfolding the wheelchair
Place the wheelchair on the ground. Unfold the wheelchair using the armrests.
Then press the sides of the seat so that all the elements fit together.
Step 2. Backrest and seat
Li� the backrest upwards and lock it with backrest locks which are located below
the hand grips (3). Fix the upholstery with bag on the wheelchair.
Step 3. Footrests
Fix the footrest on the outer side of the frame. Then turn the footrest inwards
un�l it is locked.
Step 4. Armrests
The armrests are �ltable. To raise the armrest, press the buton located on the
frame (5) of the wheelchair.
Step 5. Height adjustment of the footrests and armrests
• Adjust the footrests using set of assembly keys. To adjust, unscrew the screw
located on the footrest frame. Enough space should be le� between the
footplates and the ground as footplates set too low may cause difficul�es in
climbing hills and curbs. Adjust the footplates so that the angle between
trunk and thighs is 90
• To adjust armrests pull the adjus�ng clamp and pick the desired height. Both
armrests should be on same height level.
Step 6. Assembly of protec�ve straps
Atach the protec�ve straps to the footrests to prevent the user's legs from sliding
down the footplates.
FOLDING
The wheelchair can be re-folded in order to be transported and stored more
easily.
• Swing away the footplates and set them in ver�cal posi�on or remove.
Detach the seat and backrest upholstery with bag. Li� the seat upwards by
grabbing it from back and front un�l the frame of the wheelchair is folded.
BACKREST FOLDING FUNCTION
• To fold the backrest, simultaneously press locking elements which are
located under the hand grips at the back of the backrest and pull the
backrest downwards.
(op�mum si�ng posi�on for the user).
0
32