Built-In Led Light - Durofix Ri2036A1 Produktinformationen

A forward/reverse control button determines the direction of the tool and also serves as
a lock off button. To select forward rotation, RELEASE THE VARIABLE SPEED
SWITCH (see Fig. 1A), and depress the forward/reverse control button (see Fig. 1B),
toward left side of the tool. To select reverse, depress the forward/reverse control
button, toward right side of the tool. The center position of the control button locks the
tool in the off position. When change the position of the control button, making sure
the trigger is released.
NOTE:
The first time the tool is run after changing the direction of rotation, you may hear a click on start
up. This is normal and does not indicate a problem.

BUILT-IN LED LIGHT

A built-in LED light can illuminate the work area and improve vision when
drilling/driving in areas with insufficient light.
ELECTRIC BRAKE
The variable speed switch is equipped with a circuit design electric of brake function.
The tool will consistently operate to quickly stop rotating after the switch release.
BATTERY POWER INDICATOR
Trigger the tool and Battery Indicator to show the
battery pack's remaining capacity
1. One light ON: 30% remaining capacity.
2. Two lights ON: 60% remaining capacity.
3. All lights ON: 100% remaining capacity.
NOTE
Always check the direction of the rotation before use.
NOTE
Due to the auto shut-off function, if tool is repeatedly operated on and off in a short
time frame, the MCU will determine it as being over current resulting in tool shut down. This
phenomenon occurs most frequently in the first torque stage.
1. After continuous use, allow the impact wrench to sit idle for 15 minutes before
replacing the battery. The temperature of the motor, switch, etc., will rise if the
1English1
Fig. 1
English
-12