DUROFIX RI2036A1 Produktinformationen Seite 12

Max. Torque value: 800 Nm (590 ft-lbs)
NOTE
Please note these values are lab. test value for reference only. Accuracy varies due to
bolt size, grade, and various other factors.
LED INDICATING LAMP SIGNAL & MESSAGE ON LCD DURING
OPERATION:
1. During Operation: LCD will show the setting stage of digital clutch.
2. Designated Torque Reached: LED indicating lamp will stay on in
green and LCD will show the setting stage of digital clutch.
3. When the battery voltage is under 14.5 V, the power will be cut-off. At the same
time, LED indicating lamp will be on in red and LCD panel will show "LV".
4. When the battery temperature is over 154.4°F (70°C), the power will be cut-off. At
the same time, LED indicating lamp will be on in red and LCD panel will show
"OH".
5. When the battery temperature is lower 5°F (-15°C), the power will be cut-off. At
the same time, LED indicating lamp will be on in red and LCD panel will show
"LT".
6. When the battery output current is over, the power will be cut-off. At the same
time, LED indicating lamp will be on in red and LCD panel will show "OC".
MEMORY FUNCTIONS:
Certain work environments requires a constant working torque range. The memory
function will hold the selected torque setting until it has been adjusted.
VARIABLE SPEED SWITCH
The variable speed switch provides safety feature to the user for screw driving.
To turn the tool on, squeeze the trigger switch. To turn the tool off, release the trigger
switch (see Fig. 1A).
Your tool is equipped with a brake. The chuck will stop as soon as the trigger switch is
fully released. The variable speed switch enables you to select the best speed for a
particular application. The farther you squeeze the trigger, the faster the tool will
operate.
Use lower speeds for starting holes without a center punch, drilling metals or plastic,
driving screws and drilling ceramics, or in any application requiring high torque.
Higher speeds are better drilling in wood, wood compositions and for using abrasive
and polishing accessories. For maximum tool life, use variable speed only for starting
holes or fasteners.
NOTE:
Continuous use in variable speed range is not recommended. It may damage the switch and
should be avoided.
FORWARD / REVERSE CONTROL BUTTON
1English1
English
-11