Brightness Adjustment - Fnirsi Dst-201 Benutzerhandbuch

4.3 Adjust Oscilloscope Parameters
Oscilloscope Adjustment
In the default interface, short press the left or right key to select the function
module oscilloscope, and click "Enter" to enter the oscilloscope. Long press
the mode switch key (MODE) to enter the oscilloscope parameter setting. You
can select and set parameters at relevant selection area, such as coupling type,
probe ratio, trigger mode, trigger edge, etc. Long press the mode switch key
(MODE) again to close the oscilloscope parameter setting.
Oscilloscope Function Interface

4.4 Brightness Adjustment

Brightness Adjustment
In the default interface, short press the selection key to select system settings,
click "Enter" to enter the system settings, click the selection key to select sound
and light settings, and then click "Enter" to enter the sound and light settings,
select the brightness then press left or right selection key to adjust the
brightness in real time.
Adjust Other Functions of System Settings：
The corresponding function selection and opening are roughly the same as
the above operation navigation, and the step description is omitted
Long press
Oscilloscope Parameter
Short press
Setting Interface
EN