Technical Data; Installation - Electrolux ERB29233X Benutzerinformation

Problem
The lamp does not work.
If your appliance is still not working properly
after making the above checks, contact the
After Sales Centre.
Replacing the lamp
1. Disconnect the appliance.
2. Push the movable part to unhook the
lamp cover (1).
3. Remove the lamp cover (2).
4. Replace the lamp with one of the same
power and specifically designed for do-
mestic appliances only.
5. Install the lamp cover.
6. Connect the appliance.
7. Open the door. Make sure that the lamp
comes on.

TECHNICAL DATA

Dimension
Height
Width
Depth
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
ERB29233X ERB34233X
ERB29233W ERB34233W
1540 mm 1750 mm
595 mm 595 mm
658 mm 658 mm
20 h 20 h
230 V 230 V
50 Hz 50 Hz
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
1
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
ERB36233X
ERB36233W
1850 mm
595 mm
658 mm
20 h
230 V
50 Hz
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
electrolux 25
Solution
2
ERB40233X
ERB40233W
2010 mm
595 mm
658 mm
20 h
230 V
50 Hz