EN
USE YOUR WINE CELLAR
The temperature setting allows you to adjust it according to your needs:
• Setting temperature before tasting red wines: Temperature recommended 10-14℃.
• If the ambient temperature is higher or lower than the recommended temperatures,
this will have a negative impact on its performance. For example, placing the unit in
an extremely cold or hot place can cause variations in the internal temperature of
the unit.
• The internal temperature may vary depending on the location of the bottles, at the
top, middle or bottom.
• Adjustment may be necessary depending on the ambient temperature.
• Do not hesitate to leave a thermometer inside the cellar in order to carry out regular
monitoring.
• This wine cellar is designed for the maximum storage of 48standard size (75cl)
bottles of wine.
Temperature setting:
• Press the key(▲)or(7)3-5 seconds to unlock the button, then allow you adjust the
temperature.
• The keys ▲ >and (▼) allow you to increase or decrease the temperature in
increments of 1℃(the temperature range is 5~20℃)
• The button(
• The button (
• To minimize energy consumption, be sure to respect the filling capacity of your wine
cellar-48 «Bordeaux75cl»size. The combination of drawers, baskets and shelves
that result in the most efficient use of energy for the appliance.
Energy saving tips
• The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
• Appliance storage bin should not be lined with aluminum foil, wax paper, or paper
towel. Liners interfere with cold air circulation, making the appliance less efficient.
• Organize and label wine cellar to reduce door openings and extended searches.
Remove as many items as needed at one time, and close the door as soon as
possible
TIPS
• The light source is not replaceable; when the light source reaches its end of life the
whole machine shall be replaced.
) allows you to switch the interior lighting on and off.
) with ℃ display only in Europe, can not switch to ℉.