Signal Generator - Fnirsi Dso-Tc4 Bedienungsanleitung

2.5 Signal generator

2
4
④Frequency setting: Click OK to enter the frequency/duty cycle/amplitude
selection, click OK to select the frequency and enter the third-level
navigation to set the frequency value.
⑤Duty cycle setting: Click OK to enter the frequency/duty cycle/amplitude
selection, click OK to select the duty cycle and enter the third-level
navigation to set the duty cycle.
⑥Amplitude setting: Click OK to enter the frequency/duty cycle/amplitude
selection, click OK to select the amplitude and enter the third-level
navigation to set the amplitude.
button Operation
Short Press
Long Press
Short Press
Short Press
Short Press
3
5 6
Exit button, return to the previous operation/exit mode
Turn off the power, Power off
Confirm, enter the freguency/duty cycle/amplitude
selection, adjust by
Click on/off, and click on/off again
①Battery display: This area
displays
1
battery.
②Status display: This area
displays the signal generator
on-state,
red (OFF) is off.
③Waveform category: Short
press the left and right
buttons
waveform category, a total of
13 waveforms are available.
Function
Switch to other modes
/ to set the corresponding value.
the remaining
green (ON) is on,
to select the
EN