Cyber Power PR2200ELCDSL Anleitung Seite 2

(MUTE Button):
(1) ( ): Short press the button to scroll up the function / option menu and view the information about the
UPS.
(2) Audible Alarm: Press the button for 2 seconds to enable the audible alarm (beeps once) or disable (beeps
twice) the audible alarm. The MUTE icon will appear on the LCD display when the audible alarm is disabled.
Note: The default setting is for the alarm to be in the on position.
ENTER (SETUP Button):
Setup Mode: Press the button for 2 seconds to access the setup mode's 9 functions: Utility Power, MAX O/P
Voltage, MIN O/P Voltage, Sensitivity, Low Battery Warning, Self Test, Event Reset, Return to Default
Settings, and Return to Status Display.
Short press the button (
button to access the function's options. The LCD will start flashing.
Short Press the button (
ENTER button to confirm the setting. After the setting has been confirmed, the LCD screen will stop flashing.
Note: If there is no action for 8 seconds during setup, the LCD will leave setup mode and go back to the status
display. The setting will not be confirmed.
DISPLAY + SETUP Button:
Pressing both buttons at the same time for 2 seconds will clear the EVENT counter (and beep twice).
You can also clear the EVENT counter in setup mode.
Refer to the following table for a detailed list of functions and their description.
Power On: Press the POWER button for approximately 2 seconds and you
will hear a short
steady tone (1 second). Release the button after a short beep.
Power Off: Press the POWER button for approximately 2 seconds and you
will hear a short
steady tone (1 second). Release the button after 2 short beeps.
(DISPLAY Button):
(1) ( ): Short press the button to scroll down the function / option menu
and view the information about the UPS.
(2) LCD On/Off: The default setting is the off position. The LCD display will
dim if the buttons are not touched in 60 seconds. In Line Mode, press the
button for 2 seconds to keep the LCD display always on. The LCD display
will illuminate (and beep once). Press the button again for 2 seconds to turn
off the LCD display. The LCD display will be off (and beep twice).
In battery mode, the LCD is always on regardless of the settings.
) or ( ) to view the functions. When a function is selected, press the ENTER
) or ( ) to view the options. When the desired option is selected, press the
2
EN