HOMCOM 820-249V70 Bedienungsanleitung Seite 4

EN
17. A common cause of overheating is deposits of dust and fluff entering the heater.
Ensure these deposits are removed regularly by unplugging the heater, allowing
it to cool and cleaning as described in the Care, Cleaning and Storage section.
18. Be sure that no other high current appliances are plugged into the same circuit
with your heater as an overload can occur.
19. Avoid the use of an extension cord as the extension cord may overheat and cause
a risk of fire.
20. Do not use the appliance for other than its intended use.
21. Do not use outdoors. FOR INDOOR USE ONLY.
22. Do not leave the appliance unattended when switched on.
23. Do not place objects on the product or allow objects to obstruct the inlet or outlet
openings, or operate in close proximity to walls or curtains, etc. Do not cover the
unit when in operation.
24. Do not locate the heater immediately below a socket-outlet.
25. The use of attachments or accessories not recommended or sold by the product
distributor may cause personal or property hazards or injuries.
26. This product is intended for normal domestic/household use only.
Use this heater as described in this manual. Any other uses, not recommended by the
manufacturer, may cause fire, electric shock, or injury to persons and may void the
warranty.
USING THE HEATER
1. Before inserting the plug into an electrical outlet, make sure that the electrical
supply in your area matches that on the rating label on the unit.
2. When plugged in, turn on the Main power switch at the base side of unit.
3. When in Standby mode, only
Press to access the rest of the control panel.
a) Low Power: (Press
b) High Power: (Press
c) Timer: Press
off (between 0 hour to 8 hours)
d) + , - : adjust room temperature .Temperature setting from 10-49 degree. "+" to
increase the desired temperature and "-" to decrease the desired temperature.
After setting is complete, blink for 5 seconds, then return to steady mode to display
actual room temperature.
e) Swing : Press
f) , turn on or turn off item . item always keep working 30 seconds of cool air after
turn off it . this design can protect item use longer.
WARNING:
Before removing the plug from the socket, switching off and better work for 30-60
second for cool down in condition that protecting inner parts.
on the control panel will respond to your touch.
to switch it)
to switch it)
repeatedly to set a period after which the heater will turn itself
to activate oscillation. Press it again to cancel.
3