humanscale eFloat Quattro Montageanleitung Seite 9

11
Screw the table frame to the worksurface in all four corners, using the provided silver 20mm
screws. Using the black 16mm screws, secure the long beams to the worksurface.
IF USING A NON-HUMANSCALE WORKSURFACE:
1. Holes need to be pre-drilled to accept screws.
2. If worksurface is larger than the frame it must be placed so the overhang is equal on all sides.
4x
CAUTION: If using a power drill, take care to avoid over tightening as it could damage the
screws or worksurface.
①
2x
9