humanscale eFloat Quattro Montageanleitung Seite 15

Initial Setup/Reset
Each motor and switch component should be connected according to the instructions above, and
checked for correctness before energizing. Table must be reset before initial use, follow reset steps
below.
Reset:
Long press the "Down Arrow" Key until the desk reaches its lowest position. Release the key and press
the "Down Arrow" Key again for 5 seconds. The display shows "
reset state. To exit, press and hold the "power" key until the height is shown on the display again.
Low power wake function:
If the display appears black, press any key to wake the controller and begin operation.
Up/Down:
The height of the desk can be adjusted up or down by pressing the "Up Arrow" Key or the "Down
Arrow" Key, the current height will be shown on the display.
Setting Presets:
The controller can store two preset settings, represented by the "I" and "II" Keys.
1) Set desk to desired preset height.
2) Press the "M" key, the display shows "S-" at this time, press the "I" Key or the "II" Key to record
the current height and save it in its respective slot.
Holding the "I" or "II" Key, will adjust the desk's height to the user defined presets.
Changing Units of Measurement:
1) Follow reset steps to enter "
2) The display shows "10.3" which indicates the table is in metric units. Press the "Up Arrow" to "10.4"
which indicates the table is in Imperial units.
3) Hold the power key to exit "
now be displayed in Metric or Imperial, based on choice.
Adjusting Anti Collision Sensor Level Adjustment:
This table has a gyroscopic anti collision sensor and will stop moving if an obstacle causes the table
angle to change. Follow these steps to adjust the sensor sensitivity.
1) Follow reset steps to enter "
2) The display shows "10.5" indicating a sensitivity level of 1. Using the "Up Arrow" Key, increasing to
"10.6" indicates a sensitivity of 2. "10.7" indicates a sensitivity level of 3. Sensitivity moves on a scale
from high to low, with 1 being the most sensitive and 3 the least.
3) Hold the power key to exit "
" state and long press the "II" Key for 5 seconds
" state and commit your selection. The units of measurement will
" state and long press the "UP Arrow" Key for 5 seconds.
" state and commit your selection.
" indicating the unit has entered
15