RENPHO RP-FM058R Bedienungsanleitung Seite 8

1. Unplug the appliance and allow it to cool before cleaning. You can use a soft cotton cloth
dampened with neutral detergent to wipe it clean.
2. The use of non-rated voltage not (DC 12V, 2.5A) is prohibited.
3. It is prohibited for non-professional personnel to repair the appliance or replace parts.
4. If the power adapter is damaged, it must be replaced by the maintenance department or
qualified personnel approved by the manufacturer so as to avoid potential hazards.
5. Do not use or store the appliance in wet environments or high temperatures.
6. Do not use sharp objects to handle the appliance in order to avoid damage.
The massager
does not work.
The massage
intensity is too
high or too low.
No heating or
insufficient
heating.
The touch panel
is not working
properly.
1. Disconnected power
or loose plug causing
poor contact.
2. The power button is
off or the timer has
been reset.
3. The motor auto
shuts-off due to the
device being on too
long activating
overheating protection.
1. Your foot is
positioned at the
wrong angle.
2. Didn't choose
intensity level which is
right for you.
1. The heating function
is turned off.
2. The product
structure and working
principle limits how fast
the bottom can heat
up. Therefore, the
heating-up may seem
a bit slow, 7-10 minutes
before you can feel the
obvious heat.
1. The plastic film on the
touch panel is not
removed.
2. Fingers are wet.
3. Insufficient touch area.
1. Re-plug to the power source.
2. Turn on the power button.
3. Use the massager after the motor
cools off naturally.
1. Adjust the contact angle to get
moderate intensity.
2. The massager has 4 intensity levels,
choose the intensity you prefer. We
recommend low intensity to begin with.
Or individually choose air pressure or
kneading function to reduce the intensity.
1. Turn on the Heat Button.
2. It takes about 7-10 minutes to fully
heat up. Please be patient as this is to
avoid the temperature rising too fast.
1. Remove the plastic film before use.
2. Dry your fingers before touching the
button.
3. Use your thumb to press buttons to
get better touch sensitivity.
EN-05