RENPHO RP-FM058R Bedienungsanleitung Seite 7

Connect the plug to the power source. The Power Button flashes green accompanied by a
beep sound and the massager enters standby mode. Remove the protective film from the
touch panel before use.
1. Press the Power Button to turn on the massager (Power Button will stay on green while
other buttons on white). Check the default time and intensity in the above Function part.
Press again to enter the standby mode (Only Power Button will flash green).
2. Press the Time Button to switch the auto-off time among 15, 20, 25, or 30 minutes. The
timer will reset each time you press the Time Button.
3. Press the Air Intensity Button to adjust the air intensity among 1/2/3/4/OFF.
4. Press the Knead Intensity Button to adjust the kneading intensity among 1/2/3/4/OFF.
5. Press the Heat Button to turn on/off the heating function.
1. The air pressure and kneading function can work independently. The heating function
can work only when the air pressure or kneading function is on.
2. Each press is accompanied by a beep sound and corresponding indicator light (When
off, the LED goes out).
3. If none of the heating, air pressure and kneading function is working, and the Time and
Power button indicator lights are on, the massager will enter the standby mode if there
is no further operation within 10 seconds.
4. The massager is programmed with a memory function. It will operate in the pattern set
last time once you turn on the Power Button again. The memory function will not work if
only the Timer function is working before turning off the massager, or if you cut off the
power supply.
5. The massager fits up to US Men's Size 12 (EU Men's size 46).
6. Detachable foot cover: unzip to remove and clean.
EN-04