Basic Operations - Soundmaster Pl790 Bedienungsanleitung

Caution
When set to ON, if connected to the PHONO inputs of an amplifier, for example, the output from
speakers and headphones will be very loud, which could damage equipment or harm hearing.
DC input connector
 Do not use any AC-DC adaptor other than the one included.
 Ensure that the voltage is the same as that indicated on the ac adapter identification plate.
 Connect the supplied AC adapter to a properly installed safety power socket and the plug of
the cable into the DC IN jack at the back side of the unit.
 Unplug the power cord from the outlet when you are not planning to use the unit for an
extended period.
Playing records
1. Press the "ON/OFF" button at the back side of the unit to turn it on.
Open the turntable cover slowly.
2.
3. Place a record on the turntable. When playing a 45 RPM large-hole single record, use the
included adapter.
4. Turn the "33 / 45 RPM" switch to 33 or 45 position and the "START/STOP" switch in
"START" position.
5. Move the tone arm clasp to release the tone arm.
6. Lift the "TONE ARM BRACKET".
7. You can also leave the cue lever down and moved the raised tone arm over the record and
then lower the tone arm slowly to start playback.
8. Move the tone arm to the edge of the record or the track where you want to start playback.
9. Lower the tone arm slowly until the stylus touches the record and playback begins.
When playback finishes
1. Slightly lift the cue lever or the head-shell hook and return the tone arm to its resting
position.
2. Turn the "START/STOP" switch to "STOP" to stop the turntable. When the turntable stops.
Pairing BLUETOOTH
1. Set the BLUETOOTH
mode;
2. Turn on the unit. Turn the Bluetooth control button to "ON" position.
3. The turntable is ready for connection and the BLUETOOTH
4. When the pairing is successfully performed, the turntable BLUETOOTH
is fixed.
Note: This unit will connect to the closest BLUETOOTH
minutes no BLUETOOTH
become inactive and the LED will turn red. To activate the BLUETOOTH
®
BLUETOOTH button und turn on again.

BASIC OPERATIONS

BLUETOOTH
®
to Stereo System
®
receiver device (BLUETOOTH
®
speaker can be found to pair with, the BLUETOOTH
®
TRANSMITTER
®
- headphone or speaker to pairing
®
®
speaker that is near it. If after 3
4
PL790 / English Instruction Manual
indicator LED light is flashing.
® indicator LED light
®
transmitter will
®
function, turn off the