Troubleshooting Guide - Essentiel B Rc41-328 Bedienungsanleitung

troubleshooting
Most
not sufficiently
It is advisable
INSERTION
IF THE REMOTE CONTROL
ARE UNABLE TO GET IT TO WORK
This may be caused by the incorrect code being entered into the remote control. Check that
you have closely followed
described above.
On the site https://www.cme.it/boulanger,
device to be controlled,
IF THE REMOTE CONTROL
Unplug the appliance from the mains for a few minutes,
Remov e thebatteries f rom theremote c ontrol, press theON/OFF (!) button again andinsert N EW
batteries.
Check that the remote control is pointed at the device without any obstacles between the two
devices.
When you press (even accidentally) one of the selection buttons at the top, the remote control
prepares to control a certain type of device.
Ensure you are working
correct mode of use and check that the remote control starts working
If necessary, start the RESET PROCEDURE FOR THE REMOTE CONTROL and active the remote
control again.
IF CERTAIN FUNCTIONS
Usually, the remote control RC41-328 only allows for the functions that have been transferred to
the keypad to be accessed
If you are unable to access any of the MAIN functions,
used. In this case, search for the correct code and enter it as described
OF THE REMOTE CONTROL.
Some functions on the original remote control will still not be found directly on the keypad of
the remote control RC41-328. To activate them, follow the steps as described in the section
BUTTONS AND FUNCTIONS.
guide
O WARNING! O
operating issues are caused
charged.
to check and replace them as indicated
OF BATTERIES
IS NEW AND
the instructions in the guide.
or contact SUPPORT.
IS NO LONGER
in the mode most suitable
DO NOT RESPOND
for functions that are present on the original remote control.
by the use of batteries
IN THE REMOTE CONTROL
YOU
If necessary, carefully
enter the specificcode associatedwith the
ABLE TO CONTROL
and then turn the device back on again.
for the device to be controlled;
properly again.
ON THE REMOTE CONTROL
it's likely that the incorrect
in the section ACTIVATION
that are
in the section
repeat the steps
THE DEVICE
select the
code has been