Configuration Of The Audio-Store Cable - Essentiel B Rc41-328 Bedienungsanleitung

On the remote control
button
Whenthe indicator light comes on, without releasing the button @,
at the device to control and enter the number corresponding
The remote control transmits
Release the buttons.
RC41-328, within 30 seconds,
Three successive flashes
button.
The button used loses its original function.
of all of the buttons.

Configuration of the audio-store cable

Connect the remote control
an internet connection using the audio-store cable provided, as indicated on the diagram below.
Continue as follows:
Check that the remote control has charged batteries inserted.
Connect the flat end of the cable to the three-prong connector of the battery compartment.
Connect the jack socket at the end of the cable to the computer's audio output (green jack
socket).
on the site https://www.cme.it/boulanger,
CONTROL tool and follow
In order to transfer data to the remote control, a special cable is
needed to connect to the audio output of the computer
/ smartphone
1. Check that the remote control has sufficiently
batteries inserted.
2. Check that the computer is, in fact, reproducing the sounds on the audio output of the speakers
and not on other devices
3. Cancel any special configuration on the sound card (surround or ambience sound effects) likely
to change the audio signal.
4. Connect the jack socket of the cable to the computer's
and speakers are usually connected (green jack socket).
Connect the flat end of the three-prong cable to the connector on the remote control's battery
5.
compartment.
6. Increase the audio volume to its maximum by adjusting the various controls (VOLUME / MEDIA
RC41-328, first select the mode of use, and then press and hold the
the function as soon as the last key button is pressed.
To combine the function
press and hold the desired
indicate that the function
The reset procedure
RC41-328 to another
the instructions below
(telephone, USB, etc.)
point the remote control
to the function
obtained with a button
button.
has been saved to memory.
reactivates
device (computer / tablet / smartphone)
usethe ACTIVATIONOF THE REMOTE
indicated on the site:
/ tablet
charged
audio output where the headphones
that you want to run.
on the remote control
Release the
the original function
with