Direct Entering Of Code; Resetting Of The Remote Control; Buttons And Functions - Essentiel B Rc41-328 Bedienungsanleitung

Direct entering of code

(to be done only if the specific activation code is known)
On the remote control
button @ until the indicator light turns on.
Releasethe button @
• Immediately enter the specific
Three successive flashes indicate that the procedure
If the remote control DOES NOT emit three flashes, the configuration
Repeat the procedure.
If the configuration still doesn't work, this means that the code is not recognised
remote control. In this case,

Resetting of the remote control

If necessary, you can do a full reset of the remote control to restore the factory settings.
WARNING: all user settings will be lost.
Continue as follows:
On remote control RC41-328, press and hold the button @.When
light comes on, release the button
Enter code 0100.
Three successive flashes indicate that the procedure
Buttons and functions
Some buttons on the remote control RC41-328 are only available if the original device has these
buttons.
Some functions on the original remote control will not be found directly on the keypad of the
remote control RC41-328.
Toactivatethem,log onto the webpagehttps://www.cme.it/boulanger
tool ACTIVATING THE REMOTE CONTROL and continue until you reach a cross-referenced table
of buttons between the original remote control and the remote control RC41-328.
If the function is associated
RC41-328, first select the mode of use, and then press and hold the
code identified above.
view the SUPPORT
with a number in orange,
has been done correctly.
is UNSUCCESSFUL.
section.
the indicator
has been done correctly.
continue as follows:
by the
andthen usethe