Deletion Of Button Functions - Essentiel B Rc41-328 Bedienungsanleitung

The acquisition of signals can be done on all buttons on the remote control RC41-328 except for
button and the selection buttons. THE button used loses its original functionality, which will
be restored if the remote
The acquisition can be repeated numerous times, the signals acquired will remain saved to memory
even if the batteries are depleted or removed.
POSITIONING OF THE REMOTE
Check that the batteries of both remote controls are sufficiently charged. With depleted batteries,
the procedure for picking up signals can fail or be laborious.
Position the original remote control facing the remote control RC41-328, so that the areas that emit
the infrared signals are located level to one another, at a distance of approximately 2 cm apart.
On the remote control RC41-328,
a few seconds, briefly press the button
• In the next 30 seconds, keep any button on the original remote
control pressed down. The light on the remote control RC41-328
should start to flash. If this is not the case, bring the two remote
controls closer together.
• Increase the distance between the two remote controls by slowly
moving the original one away while keeping it level with the other,
until the light stops flashing.
Now, bring the remote control back to half the distance found and
hold the position until the end of the procedure.
CAPTURING OF SIGNALS
On the remote control RC41-328 press and hold the button
on. Release the button
Briefly press the button
signal to be captured saved.
Press and hold the button of the original remote control to capture until the light indicator turns
off. Release the button
WARNING: If, when you release the button, the indicator light turns on again, press and hold the
same button once more, until it turns off.
When the signal has been correctly captured, the indicator light produces three successive
flashes.
Repeat the procedure to capture
Deletion of button
To delete the function associated with a single button, follow these steps:
On the remotecontrol RC41-328,first selectthe mode of use,then press and holdthe button @
When the indicator light turns on, without
Release the buttons.
control is reset.
CONTROLS
first select the mode of use. After
again and then briefly press the button on which you would like the
other signals and associate
functions
@ until the indicator light turns
them with the various buttons.
releasing the button
ooo
ooo
enter code 1600.