Starting; Operation; Stopping The Engine; Fuel - Texas A/S TG 620 Bedienungsanleitung

2. Starting

1. Open the fuel tap.
2. Turn the choke lever to the left by a cold engine.
Note: By a hot engine choke is not required.
3. TurЧ tСО ОЧРТЧО's РКs МШЧtrШХ МШЦЩХОtely to the left, thereby full gas is applied.
(If the engine is mounted on a machine with cable-regulated gas, full gas is given).
4. Turn the throttle МКЛХО tШ "stКrt ЩШsТtТШЧ".
5. Pull the recoil starter gently until you feel resistance in the rope. Then pull quickly and
energetic. Do not at any time let go of the recoil starter but slide it gently back and pull
again.
6. Regulate the choker until the engine is running smoothly.
See fig. 1, 2, 3, 4.

3. Operation

1. When the engine has been started move the choke gradually to the right.
2. Adjust the gas to the requested speed.
See fig. 2.
Please observe the following during operation.

Exhaustion must not be black. If the exhaustion is black the load is too high or the engine
has not been adjusted correctly.

Unpleasant sound and vibration.

If these appear turn off the engine and adjust it. Contact your dealer

4. Stopping the engine

1. Turn the gas controХ Кt tСО "low" ЩШsТtТШЧ КЧН ОЧРТЧО аТХХ stШЩ ruЧЧТЧР.
2. Turn the fuel tap tШ tСО "ШПП" ЩШsТtТШЧ
See fig. 3.

5. Fuel

DШЧ't ШvОrПТХХ tСО МКЩКМТtв ШП the fuel tank The indicator on the tank shows how much fuel is left
See fig 7
TG620 / TG720 / TG820
PROCEDURE
OPERATION
PROCEDURE
Only use unleaded fuel octane 95 on your engine.
NOTE
FUEL
3,6 Litre / 3,6 Litre / 6,5Litre
11