Intenso MW10000 Bedienungsanleitung Seite 15

Wired charging:
This power bank features a USB-C port (USB-C In/Out), which can be used to charge devices. It supports
the Power Delivery (PD) standard.
To charge your device with a USB-C port, simply use the included USB-C to USB-C cable. Of course, you can
also use your own USB cable to connect the power bank to your device. Please note that for PD, a cable
that supports this standard is required (you may want to check with the manufacturer of your USB cable).
For wired charging of your device, simply connect the included cable to the USB-C port (USB-C In/Out) of
the power bank and the other end to the USB-C port of the device to be charged, or alternatively use your
own USB-C cable.
The charging process starts automatically, and the devices will independently determine the appropriate
charging current. If fast charging is not possible, the function LED will remain off, and the device will be
charged with a maximum of 15 watts (5.0 V/DC 3.0 A). If fast charging via PD is activated, the function LED
will light up green, and the device will be charged with a maximum of 20 watts (9.0 V/DC 2.22 A or 12.0 V/
DC 1.67 A).
When a device is charging from the power bank and the power bank's capacity is nearly exhausted, this
will be signaled by the last LED blinking when the remaining capacity is around 3%. Please recharge the
power bank soon.
Please note that during device charging, around 30% of the total capacity of the power bank is consumed by
the charging process itself. This is due to power loss from circuit heat and voltage conversion.
For optimal performance, the power bank should be used regularly. If this is not the case, make sure to fully
charge the power bank at least every three months.
Ensure that the heat generated by the charging process can dissipate from the device (ideally, place the
power bank on a firm and heat-resistant surface during use). Do not use the device in bags or other enclo-
sed spaces to avoid overheating caused by heat buildup.
SERVICE / DISTRIBUTOR
INTENSO INTERNATIONAL GMBH I Kopernikusstraße 12-14 I D-49377 Vechta
Email (technical support):
Email (RMA number):
Internet:
Telephone (technical support):
OPERATING CONDITIONS
Operate the device at 0 to 40 degrees Celsius and a maximum humidity of 90 % (for a short time). If you do
not use your device for a longer period, store it at between -10 and 45 degrees Celsius at max. 90 % relative
humidity (for a short time) and charge this every three months to maintain full capacity.
support@intenso.de
rma@intenso.de
www.intenso.eu
+49 (0) 4441 – 999 111 (Mon. – Thur. 09:00 – 16:30;
Fri. 09:00 – 14:00)
EN - Page 6 of 7