Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Tips
-
Generally, hedges that lose their leaves in autumn should be pruned in June and October.
-
Evergreen hedges, on the other hand, should be pruned in April and August.
Cutting grass
Fig. 5
-
Pass the tool over the grass. Keep in mind that you will get better results if the lawn is dry.
-
If you notice that the power of the tool is decreasing, recharge it; do not wait until the
battery is completely discharged.
Adjusting the handle angle
Fig. 6
-
Press the handle rotation button (9).
-
Place the handle (10) in the desired position.
-
Release the button (9).
Replacing the blade
Warning: Risk of injuries. Be careful when replacing the blade.
-
To fit or replace the blade, hold the hedge trimmer by the handle.
-
Then press the blade release button and pull the blade down as shown in figures 7 and 8.
-
To fit a new blade, insert it into the base of the hedge trimmer until it is firmly locked in
place.
4. CLEANING AND MAINTENANCE
Cleaning
Make sure that the hedge trimmer is switched off and disconnected from the mains before
carrying out any cleaning or maintenance task.
-
Keep all safety systems, ventilation openings and motor housing free of dirt and dust as
far as possible. Clean the tool with a damp cloth and some mild soap.
-
The tool should be cleaned after each use.
-
Do not use cleaning products or solvents, as they may damage the plastic parts of the tool.
Make sure that no water enters the hedge trimmer.
-
You can put a few drops of lubricating oil to improve the performance of the blades.
However, the lubricant must be specific for this purpose, no other type of oil should be
used.
-
To ensure an accurate cut, it is also important to remove any grass debris and dirt that may
have accumulated between the upper and lower blades.
WARNINGS:
Do not clean the tool by directly placing it under running water or using a pressure washer.
144
TITANIUMSWORD 2000 HAND
Original instructions
Store the hedge trimmer in a dry place where it will not be exposed to adverse weather
conditions. Also keep it out of the reach of children.
Maintenance
For good results, you must always keep the blades sharp.
Battery removal procedure for proper recycling
This procedure should only be performed when the tool is intended for disposal, and not for
battery replacement, as it is a complex process that may damage the product and pose a risk
of injury. The following steps are necessary to ensure safe and responsible removal:
1.
Disassemble the product by removing the screws that hold the two plastic parts of
the main body together.
2.
Disconnect the battery and remove it.
3.
Properly recycle both the product and the battery.
5. TROUBLESHOOTING
The tool is maintenance-free. If you detect a fault, do not attempt to repair the tool by yourself.
Contact the official Cecotec Technical Support Service.
6. TECHNICAL SPECIFICATIONS
Product reference: EU01_102261
Product: TitaniumSword 2000 Hand
Battery: 7.2 V, 2 Ah
To recharge the battery, it is recommended to use an adapter with the following characteristics:
Input: 100-240 V~, 50/60 Hz
Output: 5 V ⎓, 2 A
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
ENGLISH
145
TITANIUMSWORD 2000 HAND
Original instructions
Werbung
