cecotec TITANIUMSWORD 2000 HAND Bedienungsanleitung Seite 72

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Lawn cutting blade
2. Safety lock
3. Trigger
4. Blade release button
5. Hedge trimming blade
6. USB Type-C cable
7. Indicator light
8. Charging port
9. Handle rotation button
10. Handle
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and
other packaging elements in a safe place to prevent damage to the appliance if you need
to transport it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Hedge trimmer
- Side cutting head for hedges
- Front cutting head for lawns
- USB Type-C cable
- Instruction manual
Do not remove the serial number of the appliance in order to keep a correct traceability of it in
case of assistance.
142
TITANIUMSWORD 2000 HAND
Original instructions
3. OPERATION
Battery charging (Fig. 2)
- Connect the charger to the tool and plug it into the mains.
- During charging, the indicator light will turn on in red.
- The battery takes 3 to 5 hours to fully charge.
- When the hedge trimmer is fully charged, the indicator light will turn green.
For safety reasons, you cannot use the hedge trimmer while it is charging.
Note: The battery is built-in to the tool. If you ever need to replace it, do not attempt to do so on
your own. Contact the official Cecotec Technical Support Service to replace it safely.
When you notice that the power of the hedge trimmer decreases, charge the battery. Do not
wait until it is completely discharged, otherwise the battery may be damaged.
First, make sure that there are no stones or other obstacles in the area where the hedge
trimmer is to be used.
Please note that the safety lock prevents the tool from operating unintentionally.
WARNINGS:
The blades continue to move for a few seconds after the tool is switched off. For this reason,
before cleaning, turn it off and wait until the blades have come to a complete stop.
Do not touch the blades under any circumstances, especially when the tool is in operation.
Switching on the hedge trimmer (Fig. 3)
To unlock the tool, push the safety lock and press the trigger at the same time.
Switching off the hedge trimmer
To turn the tool off, simply release the trigger.
The hedge trimming blade (5) is used for cutting hedges and bushes (Fig. 4), while the lawn
cutting blade (1) is used for cutting grass and hedges with a higher degree of precision (Fig. 5).
Trimming hedges
Fig. 4
- Hold the tool at a slight angle to the hedge to be cut. First cut both sides of the hedge
(bottom to top) and then cut the top.
- Make sure that there are no foreign objects in the hedge, otherwise the blades may be
damaged.
ENGLISH
143
TITANIUMSWORD 2000 HAND
Original instructions