Werbung
Verfügbare Sprachen
Verfügbare Sprachen
This document provides updated information for your system on the following topics:
•
Enabling video hardware acceleration in the Microsoft
system
•
Correcting flat-panel display video problems during Microsoft Windows Server 2003
operating system installations
•
PCI-e hot-plug support
•
Failure to load usb-ohci driver message on systems running Red Hat
(version 2.1)
•
NIC teaming limitations
•
Changing the LCD display of the system ID and name
•
LCD status messages update
•
Installing the cable-management arm
Enabling Video Hardware Acceleration in the Microsoft
Windows Server 2003 Operating System
By default, video hardware acceleration is set to its lowest setting (None) by the Microsoft
Windows Server 2003 operating system. Your system's video controller supports enhanced features
and requires that the video hardware acceleration be set to its highest (Full) setting. Operating
the system without adjusting the video hardware acceleration to its highest setting may cause the
system to become unstable under certain conditions. To adjust the video hardware acceleration:
1 Click Start, point to Control Panel, and then click Display.
You can also right-click the desktop, and then click Properties.
2 Click the Settings tab in the Display Properties window, and then click Advanced.
3 Click the Troubleshoot tab, and move the hardware acceleration slider from None to Full.
4 Click OK, and then click OK.
If you reinstall or update the video drivers, or if you reinstall Windows Server 2003, you must reset
the video hardware acceleration to its Full setting again.
®
®
Windows
Server 2003 operating
®
Enterprise Linux
Information Update
3
Werbung
