FCC Regulatory Compliance
Wa ning: Changes or modifications not expressly approved by the
pa ty responsible for compliance could void the use 's autho ity to
operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to pa t 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against ha mful inte ference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the inst uctions,
may cause ha mful inte ference to radio communications. However,
there is no guarantee that inte ference will not occur in a pa ticular
installation. If this equipment does cause ha mful inte ference to
radio or television reception, which can be dete mined by tu ning the
equipment off and on, the user is encouraged to t y to co rect the
inte ference by one or more of the following measures:
Reo ient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an expe ienced radio/TV technician for help.
ISED Regulatory Compliance
This device contains licence-exempt transmitters that comply with
Innovation, Science and Economic Development Canada's
licence-exempt RSS(s).
Operation is subject to the following two conditions:
1 This device may not cause inte ference.
2 This device must accept any inte ference, including inte ference
that may cause undesired operation of the device.
Le présent appareil est confo me aux CNR d'Indust ie Canada
applicables aux appareils radio exempts de licence. L'exploitation est
auto isée aux deux conditions suivantes:
1 l'appareil ne doit pas produire de brouillage.
2 l'utilisateur de l'appareil doit accepter tout brouillage radioélec t ique
subi, même si le brouillage est susceptible d'en compromettre
le fonctionnement.
EN 16