cecotec FAST&FURIOUS 5040 ABSOLUTE Bedienungsanleitung Seite 17

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1.
1. Steam selector
2. Steam-burst button
3. Spray button
4. Temperature light indicator
5. 360º swiveling cord
6. Temperature-control dial
7. Water tank
8. Soleplate
9. Spraying mouth
10. Water tank cap
11. Auto-clean button
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
product.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent product damage when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If any of them
are missing or not in good condition, please contact the official Cecotec Technical Service
immediately.
- Make sure you have read and understood all instructions and warnings in this instruction
manual. Pay particular attention to the safety instructions on previous pages.
- Place the appliance on an even, heat-resistant surface. Do not place the appliance near
heat sources, places with high humidity levels, or combustible materials.
- Plug the appliance into an appropriate wall outlet. The plug must have easy access, so
that it can be easily unplugged in the case of an emergency.
Please note
You may notice a slight burning smell or smoke when using the appliance for the first time,
caused by the excess of lubricants from the manufacturing process. Ensure good ventilation
and let the appliance work until no odour or smoke is noticed.
FA S T & F U R I O U S 5 0 4 0 A B S O LU T E
32
How to fill the water tank
- Make sure the iron is turned off and unplugged from the mains supply before following
the below instructions:
1. Turn the steam selector to position '0' before filling the tank with water.
2. Open the tank cap, tilt the iron, and fill it up to the "MAX" sign. The water level can be
seen through the transparent part of the tank when the iron is placed upright. Close the
tank cap.
3. Pour out the remaining water after use.
Please note
The iron can be used with tap water, although we recommend using distilled, purified, or
filtered water in order to reduce mineral build-up. Do not use water additives or substitute
water, such as linen or scented water. They can stain fabrics or damage the iron. Do not
exceed the "MAX" mark on the tank.
3. Operation
Icon key:
Synthetic-fibre temperature
Silk and wool temperature
Cotton and linen temperature
Dry ironing
1. Place the iron in vertical position.
2. Plug the iron into the power supply.
Place the steam selector in the OFF position.
3.
4. Turn the temperature-control dial according to the type of fabric. The two light
indicators will come on
5. Preheat the iron until the right-hand light indicator turns off.
The iron is ready for use.
6.
Steam ironing
7. Fill the iron as described in "How to fill the water tank".
Plug the iron into the power supply.
8.
9. Place the iron upright and put the steam selector in the
10. You can adjust the steam flow from no steam to maximum steam. For high steam flows,
it is recommended to set the temperature-control dial to the
11. Preheat the iron until the indicator light turns off.
12. Turn the steam selector to the required setting, according to the different types of fabric.
13. The iron is ready for use.
ENGLISH
or position.
position.
FA S T & F U R I O U S 5 0 4 0 A B S O LU T E
33