Beninca RR.4WBV Betriebsanleitung Seite 9

SINC
FIX
add
ser
Menu to erase previously typed in transmitter codes from memory.
The single submenus are described hereunder:
DEL
code
indh
The receiver memory is completely erased. All transmitter codes and relevant associations and channel
parameters are cancelled.
res
A confirmation of the operation is being asked.
Search Menu for transmitter codes stored in memory.
The single submenus are described hereunder:
find
Code
N Tx
According to the typing in mode, the synchronism control may be activated or deactivated.
Transmitters with activated synchronism control
This is the default mode which allows synchronism between transmitter and receiver, thus ensuring the safety offered by
the rolling-code system.
Transmitters with deactivated synchronism control
In this mode, the synchronism function is disabled and the transmitter code can be copied. Hence, by using the Advantage
system, a virtually infinite number of transmitter codes identical to the original can be created.
The four keys of a four channel transmitter are automatically associated, each one to the cor-
responding channel. (Key1:ch1, key2:ch2, key3:ch2 and key4:ch4).
Press, within 5 seconds, any key of a four channel transmitter.
Synchronism control is activated (see Synchronism paragraph).
The four keys of a four channel transmitter are automatically associated, each one to the cor-
responding channel. (Key1:ch1, key2:ch2, key3:ch2 and key4:ch4).
Press, within 5 seconds, any key of a four channel transmitter.
Synchronism control is not activated (see Synchronism paragraph).
Serialised remote controls are typed in.
Packages of factory serialised remote controls, i.e. transmitters with consecutive codes. First
of all press any key on the transmitter with lower serial code, then any key on the transmit-
ter with higher serial code. All transmitter codes which are within these two codes will be
automatically stored in memory. Associations are automatically carried out (key1:ch1, key2:
ch2, etc)
Synchronism control is activated (see Synchronism paragraph).
The receiver is in a waiting mode, waiting for a memorized transmitter key to be pressed.
The transmitter is erased from the receiver memory.
Remove a control unit code for which the position in memory is know, see function Find>Code
La ricevente si pone in attesa di un codice, premere un pulsante del trasmettitore, se presente
visualizza la posizione in memoria.
The number of transmitter codes stored in the receiver memory is displayed.
SYNCHRONISM
9