Beninca RR.4WBV Betriebsanleitung Seite 8

Press PG to select the desired value. OK is shown to confirm a successful programming.
After 60 sec wait, the receiver exits the programming mode and the display switches off.
Each single function, which is available in the control unit, is described in the following tables.
MENU
The operating mode of channel 1 is preset.
The descriptions of the single submenus are shown hereunder:
IMp
TG
MCH1
time
cont
MCH2 Same operating modes preset for MCH1.
Same operating modes preset for MCH1.
MCH3
Same operating modes preset for MCH1.
MCH4
MENU
With this function enabled, channel 1 switches only if the corresponding key is pressed for longer than 3
seconds.
safe
This function is useful specially to control alarm installations or in cases when accidental activation is to
be averted. The default function is preset on OFF.
MENU
Menu to type in the transmitter codes in memory. The message FULL means that the receiver memory is
complete. The submenus are described hereunder:
CH1
CH2
Add
CH3
CH4
8
Monostable. The relay activates for 1 sec when the corresponding key is pressed; then the
relay returns to its original status.
Bistable. When the associated key in the transmitter is pressed, the relay activates. It remains
in its new status until the key is pressed again.
Timed. The switching time of the relay can be set between 1 second and 10 minutes. By us-
ing the <+> and <-> keys, select the desired time. The presettable values are:
from 1 to 10s with 1s steps
from 30s to 300s with 30s steps
from 300s to 600s with 60s steps.
The relay switches each time the corresponding key in the transmitter is pressed and returns
to its original status after its realise.
The key is associated to channel 1. Press, within 5 sec, the transmitter key which is to be as-
sociated to channel 1.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 2. Press, within 5 sec, the transmitter key which is to be as-
sociated to channel 2.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 3. Press, within 5 sec, the transmitter key which is to be as-
sociated to channel 3.
Synchronism control is activated (see Synchronism paragraph).
The key is associated to channel 4. Press, within 5 sec, the transmitter key which is to be as-
sociated to channel 4.
Synchronism control is activated (see Synchronism paragraph).
PARAMETERS
FUNCTION
LOGICHE
FUNCTION
RADIO
FUNCTION