Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Removing the guide plate
• Even when not using the template guides, the Guide Plate
(1 or 2) can remain fitted to the router for the majority of cuts,
whether using the router hand-held or table-mounted
• However, if using cutters with a diameter greater than 50mm
(2"), the Guide Plate (1 or 2) will need to be removed
• To remove the guide plate, follow the fitting instructions above in
reverse
Maintenance
WARNING: Always disconnect tools from the power supply
before carrying out any maintenance/cleaning.
General Inspection
• Regularly check that all the fixing screws are tight. They may
vibrate loose over time
• Regularly check that the M4 Screws (4) are tightened firmly
• When not using a guide bush, consider removing the M4 Screws
and Alignment Bush (3) for safe storage
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal
parts to wear quickly, and shorten the device's service life.
Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the
ventilation holes (where applicable)
EN
6
Contact
For technical or repair service advice, please contact the
helpline on (+44) 1935 382 222
Web: www.tritontools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Hogeweg 39
5301 LJ Zaltbommel
The Netherlands
Werbung
