Genius Chef Gebrauchsanleitung Seite 26

GB
Sandwich
Waffles
NOTE: The preset times and temperatures are approximate values. The cooking time may vary considerably if the
thickness of the food differs from that in the test. Check the cooking status with the thermometer if necessary.
Select the desired programme by touching the respective symbol. As soon as a programme has been selected, the
„
corresponding symbol flashes blue and the stored settings for temperature and time are displayed.
Press the start/stop button
„
During heating, the LED indicators on the time display move in a circle.
„
When the set temperature reached, 3 short beeps sound and „ready" appears above the plate symbols. A few
„
seconds after the signal tone, the timer starts to run.
When the timer has elapsed, 5 short beeps sound.
„
If the programme is not restarted, the appliance switches to standby mode after 20 seconds.
„
No manual adjustment of temperature or time is possible while a preset programme is running.
„
If you want to select a different programme or adjust the settings while a programme is running, press the start/
„
stop button and wait a moment. The initial menu is then shown on the display again and you can make the
desired settings.
Use of the thermometer:
Use the thermometer to check the temperature inside the food.
„
To measure the temperature at a desired time, connect the thermometer to the appliance, insert the probe into the
„
food and read the temperature.
You can also leave the probe in the food during the entire cooking process and set a target temperature.
„
To do this, connect the thermometer to the appliance by opening the small cover on the left-hand side of the
„
display and inserting the plug.
The thermometer symbol on the display, the timer display disappears and now shows the temperature of
„
the thermometer.
26
Instruction manual
210 °C
180 °C
to start the heating phase. Only the selected programme is illuminated on the display.
6:00 Min
4:30 Min