ProfiOffice Prolamic 330 Plus Bedienungsanleitung Seite 9

Quality problems in lamination and solutions
Problems
Poor transparency with
white spots on the
laminated graphics
Laminated picture and text Laminated picture and text
appears with a few white appears with a few white
spots in the front zone spots in the front zone
Undulated surface of the
laminated graphics
Different quality on the two
sides after lamination
Problems
Machine does not run when
power is switched on
Film is entangled into
machine
Causes
Low operating
temperature
Dust on surface of
graphics
Poor film quality
The film is fed at The film is fed at
over-speed over-speed
Operating temperature
is too high
Object to be coated
found with wrinkles
and damage
Uneven pressure on
two sides of the
machine
Problems in machine and solutions
Causes
Power plug is not
properly connected
with the socket
1. Over-temperature in
the machine
2. Film or article for
lamination is too
thin
3. Excessive dirt on
the rolls
Solutions
Properly tune up the set
temperature
Wipe the surface of the
graphics clean
Replace the film
Reduce the film feed-in
Reduce the film feed-in
speed adequate to
speed below 0.6m/min.
roller speed
Properly tune down the
set temperature
Replace the object
to be coated
Pls. contact service
center
Solutions
Correctly pluged
1. Immediately press REV
button to withdraw the
film
2. Align the temperature.
3. Remove the dirt from
the rubber rolls
G.B. G.B.
9