ProfiOffice Prolamic 330 Plus Bedienungsanleitung Seite 7

1. Switch the power switch on and the power indicator will turn on red light.
2. Select the laminating pouch format according to the size of paper.
3. Place the paper/photo into the laminating pouch like shown i n Fig. A and B.
4. Adjust the temperature control to the right level according to scetch of temperature
control on page 3.
5. Red light is indicating that machine is heating up. Normally 3-5 min.
6. Green Ready light indicates machine is ready and reached selected temperature.
7. Insert laminating pouch in the front of the machine and align pouch in the center width.
8. The laminator will feed the laminating pouch through heat rollers to the back of the
machine.
•
Use standard sheet laminating film as far as possible.
after laminating. Cut pouches can leak glue in to your machine. Pouches are also
easier to cut accurately when laminated.
•
Place the object to be coated between the prepared laminating films with the front
close to the edge-sealing position as far as possible (as shown in Fig. B).
•
Flatly place the films covering the object to be coated at the film inlet and feed them
flatly in the machine. When laminated, the object coated will come out of the rear of
the machine.
•
When object coated comes out of the rear of the machine, immediately move it to a
plane for cooling.
Operating instruction
Be carefull during operation
Pre-sealed
edge
Fig. A
If you need to cut a pouch do so
Object to be
coated
Laminating
film
Fig. B
G.B. G.B.
7