Quick BX 15 Benutzerhandbuch Seite 15

POS. DESCRIPTION
2 Red plastic washer
3 White plastic washer
4 Blue plastic washer
5 Relief/non return valve
6 Hose clamp
7 Discharge pipe
8 A Element gasket
from S/N 100.000
8 B Element gasket
from S/N 200.000
9A Electric element
1200W 220V
9B Electric element
500W 220V
9C Electric element
1200W 110V
9D Electric element
600W 110V
10 Bi-Thermostat
11 Power supply cable
12A Boiler resistor cover 220V
12B Boiler resistor cover 110V
13 Nut
14 Ground cable terminal
15 Washer
16 Screw 2,9 x 19
17A Tank mounting
BX15-BX20-BX25
17B Tank mounting
BX26-BX30-BX40
17C Tank mounting
BX41-BX50-BX60-BX80
18 Bolt
19 Washer
20 Nut
21 Cable clamp
22 Screw 2,9 x 16
BOILER BX15-100 - REV004A
CODE
PECRBLRS0000
PECRBLBNC000
PECRBLBL0000
MNVALS12S68P
• shut down power supply.
PBF25100W000
• Remove the protection cover (12) in order to reach
PVTBGM10NT00
the thermostat (10).
PGGRES000000
• Push the reset button on the double thermostat (fig. 4).
• Replace on the protection cover (12).
PGRM43500000
• Switch on power supply.
EVR12220N000
EVR05220N000
EVR12110N000
MAINTENANCE
EVR06110N000
EVT15S000000
ECC30150G000
F
PECRB2200000
PECRB1100000
MBD04MXEN000
EJCY04000000
The overpressure release device must be activated regu-
MBR04X000000
larly to remove calcium deposits and to ensure that it is
MBV02919AXCC
not blocked.
MMSTBL300DR1
Periodically check the joints of the water pipe instal-
MMSTBL400DR1
lation; check the tightness of the securing screws and
replace them in case they are worn or corroded.
MMSTBL400DR1
MBV0830MXE00
Also periodically check the electrical system working
MBR08X000000
order.
MBD08MXEN000
PPBLBX000000
MBV02916AXCC
MAINTENANCE
WARNING: Quick ® nautic water heaters are pro-
vided with a double thermostat with manual
reset that shuts down power supply in case of an
excessive water temperature.
If it happens, follow the instructions below:
WARNING: if the high temperature safety sys-
tem switches on repeatedly, call Quick
center.
During wintertime, when the water heater is not
in use it should be drained using the lever of the
valve (5). This is to avoid serious damage caused
by freezing.
GB
® service
15