Xblitz GO3 Bedienungsanleitung Seite 16

puter and then on the camera. Ultimately, each file on the data carrier
will be protected from being overwritten and the device will not be able
to record a further route - it will not record in a loop. We suggest setting
the sensor according to your driving style and road conditions. You can
also disable the option completely, in which case each oldest file will be
overwritten and the card will not need to be formatted periodically. After
adjusting the function, remember to format the memory card.
4. Camera switches on and off
Check: PARKING MODE/MONITOR and MOVEMENT DETECTION -
function designed to operate while the vehicle is parked. Deactivate
the functions, before setting off, as they can cause the camera to switch
on and off and make random fragments of the route recordings. If the
functions are deactivated, check if the fault occurs without a memory
card inserted.
5. Camera records fragments of a route / random ongoing recordings
Check: MOVEMENT DETECTION - a function designed to operate while
the vehicle is parked.
You need to deactivate the function before you set off, as it can cause
the camera to switch on and off and make random fragments of route
recordings. If the function is deactivated, check if the fault occurs without
a memory card inserted.
6. Device shows "card full" message or does not read the card
Check the "G-sensor" and "parking mode" functions and set them to
minimum. The card must be formatted in the computer in the FAT32 or
exFAT file system (depending on the card) and then in the recorder.
Also check: Is the selected card capacity and specification (micro SD, class
10 - U1, V10 additionally recommended) suitable for your device (we
recommend using cards from reputable manufacturers, we recommend:
Kingston, Samsung, Sandisk). If you encounter an error at any stage,
replace the card with a new one from official distributors.
7. The device records noise, distorted, unclear sound
The device has a highly sensitive microphone that records any ambient
noises. The recorded sounds may overlap. Windscreen air vents can also
distort the sound.
8. Device does not respond
Press the Reset button briefly or return the device to factory settings.
9. The footage shows transverse lanes
Incorrect setting of the frame rate value. Set the frequency value to
"50Hz" or "60Hz" depending on local settings.
10. Handle detaches from the windshield/does not stick
Degrease the surfaces well before mounting the holder on the glass.
16