Meec tools 011712 Bedienungsanleitung Seite 9

7 Troubleshooting
Problem
"E1" is shown on the display.
"E3" is shown on the display.
"E4" is shown on the display.
"E5" is shown on the display.
"E6" is shown on the display.
"E7" is shown on the display.
"E8" is shown on the display.
"E9" is shown on the display.
8 Discard
● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
9 Technical data
Specification
Voltage
Speed
Stroke rate
Disc
Noise levels
Sound pressure level, L
pA
Sound power level, L
WA
Maximum vibrations level
1
1
The declared values for vibration and noise, which
have been measured according to a standardized
test method, can be used to compare different tools
with each other and for a preliminary assessment
of exposure. The measurement values have been
determined in accordance with EN 62841-2-
4.
Possible cause
The over-current protection is
activated.
The product cannot start.
The overload protection is activated.
The overheating protection is
activated.
The under-voltage protection is
activated.
There is a hardware error.
The motor is defective.
The over- voltage protections is
activated.
Value
18 V DC
2100–5000 rpm
when using tools may differ from the specified maximum
15 mm
value, depending on how the tool is used and the mate-
rial. It is therefore necessary to determine which safety
Ø125 mm
precautions are required to protect the user, based on
an estimate of exposure in actual operating conditions
(taking into account all stages of the work cycle, e.g. the
78 dB(A),
time when the tool is switched off and when it is idling, in
K=3 dB
addition to the start-up time).
86 dB(A),
K=3 dB
4.56m/s ,
2
K=1.5m/s
2
Stop the product and then start it
again. If the product does not start,
refer to the retailer.
Stop the product and let it become
cool for approximately 30 minutes
and then start it again.
Charge the battery or replace it with
a fully charged battery.
Stop the product and then start it
again. If the product does not start,
refer to the retailer.
Stop the product and then start it
again. If the product does not start,
refer to the retailer.
Make sure that the correct battery is
installed to the product.
Warning! Always wear hearing protection!
Warning! The actual vibration and noise level
EN
Task
SV
NO
DA
PL
DE
FI
FR
NL
9