Meec tools 011712 Bedienungsanleitung Seite 8

Note! Be careful when you operate the product over
EN
sharp edges where the layer of paint is often thinner. The
paint will be polished quickly.
SV
● Do not polish in direct sunlight, low temperatures,
high humidity, and windy conditions. This conditions
NO
can have unwanted effect of the end result.
● Use masking tape to protect areas that must not come
into contact with polish.
DA
● Clean or replace the polishing pad when necessary to
prevent damage to the surface.
PL
1
Make sure that the surface is clean and dry.
DE
2
Attach a polishing pad to the disc of the product.
3
Apply five of drops polish the size of peas on the
FI
polishing pad.
4
FR Put the polishing pad on the surface.
5
Start the product. Refer to "3.2 To start and stop
NL
the product" on page 7.
6
Operate the product at a low speed and spread
the polisher over an area of approximately 30 x 30
cm.
7
Increase the speed and move the product slowly,
approximately 4 cm/sec, over the surface a few
times. Refer to "3.3 To adjust the speed of the
product" on page 7.
8
Apply more polish on the polishing pad when
necessary.
Note! A new or a newly washed polishing pad absorbs
more of the polish in the beginning.
9
Wipe off remaining polish with microfibre cloth
until the surface is bright.
10
If applicable, apply a thin layer of wax to the
surface and then wipe the surface with a clean
microfibre cloth.
4 Transport
● Let the product come to a complete stop and remove
the battery before you move the product.
● Use the handle to lift or move the product.
8
5 Storage
● If the product is not going to be used for a long period
of time, remove the battary, keep the product in a
clean and dry area, where children and pets do not
have access to it.
6 Maintenance
● Clean the product regularly, use a moist cloth to clean
the product.