Werbung
S0-1200
LINE INPUT - The rear-panel Line Input allows connection of other audio
sources (e.g., CD, MP3, or a second preamp) for practice or layered
amplification.
EFFECTS SEND / RETURN - A 0dB serial effects loop is provided. The
EFFECTS SEND can also act as a Line Out. The loop is only broken when a
plug is inserted into the EFFECTS RETURN.
The Effects Send is placed after the EQ, Valve Drive, Compression, and
Sub Harmonics sections.
4-WAY FOOTSWITCH SOCKET - This mono jack socket is for the
dedicated 4-way footswitch (sold separately). To enable footswitch
control, relevant front panel buttons must be in the OUT position.
Connect the footswitch before powering on. It draws power from the
amp and sends a serial data stream to control its functions. Each feature is
indicated by an LED on the footswitch when active.
SPEAKER OUTPUT - Located on the rear panel. The SO-1200 features
two power sections, each rated at 600 Watts RMS, with two Neutrik combi
Speakon/jack outputs per power section, labeled A & B.
Use Speakon or jack speaker cables to connect to your cabinets. Each
power section supports a minimum load of 4 ohms.
S0-1200
USER GUIDE
SPECIFICATIONS
INPUTS
High Input
Low Input
Line Input
Effects Return
OUTPUTS
Tuner Output
Line Output
Effects Send
D.I. Output
EQUALISATION
Shape (Push Flat)
Bass
Middle
Treble
Slider1
Slider 2
Slider 3
Slider 4
Slider 5
Slider 6
Frequency Response
Speaker Outputs
Output Power
Impedance 3.9M Ohms
Input range 150mV to 20V p-p
Impedance 10K Ohms
Input range 300mV to 40V p-p
Impedance 22K Ohms
Input level 0dBu nominal
Impedance 22K Ohms
Input level 0dBu nominal
Impedance 1K Ohms
Level 0dBu nominal
Impedance 10K Ohms
Level 0dBu nominal
Impedance 22K Ohms
Level 0dBu nominal
600 Ohms balanced
Level -20dBu nominal
+8dB @ 50Hz & 4kHz, -8dB @ 400Hz, filter slope - 6dB/octave
+/-15dB @ 45Hz
+/-15dB @ 660Hz
+/-15dB @ 7kHz shelving
+/-15dB @ 100Hz
+/-15dB @ 180Hz
+/-15dB @ 340Hz
+/-15dB @ 1.3kHz
+/-15dB @ 2.6kHz
+/-15dB @ 5kHz
-3dB at 17Hz and 22KHz
Minimum impedance 4 Ohms
600watts RMS into 4 ohms. Per Power Section
USER GUIDE
Werbung
