Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
15 minutes. In case you continue charging
or discharging a battery which has already
started to swell or deform there is a danger
of fire! Even in case of slight deforming or
ballooning the rechargeable battery has to
be taken out of operation.
• Store the rechargeable battery at ambient
temperature in a dry place.
• Always recharge the battery immediately
after use to prevent its becoming deep
discharged. Please make sure to allow a
pause of about 20 minutes between fin-
ishing the flight and recharging the bat-
tery. Recharge the battery occasionally
(suggested every 2-3 months). Failure to
treat the battery as described above can
lead to its becoming defective.
• When transporting or temporarily storing the
rechargeable battery the temperature should
be between 5-50°C. If possible, do not store
the battery or the model in a car and do not
expose it to direct sunlight. In case the battery
is broiled it can be damaged or catch fire.
Note: If the battery voltage/output is low you
will recognise that a considerable trim and/
or controlling is necessary to avoid that the
Quadrocopter starts trundling. This usually
occurs before reaching a battery voltage of
3 V and it is a good moment to end the flight.
Instruction Manual

Contents of package

1
1 x Quadrocopter
1 x Adjustable controller
1 x USB charging cable
1x 3,7 V 1000 mAh Rechargeable Battery
1 x Tablet holder
1 x 3D Goggles
2 x Replacement motor (right/left)
1x Screwdriver
2 x AAA LR03 batteries
(non-rechargeable)
Fixing the portable phone
2
A portable phone can be fixed between
both sides of the controller. Press the but-
ton in the middle of the controller for this
purpose, in order to change the width in
such a way that the portable phone is
clamped and it cannot slip out of position.
Mount the tablet holder.
3
if you want to use a tablet in your control-
ler, then we recommend that you mount
the supplied holder for reasons of safety.
Push the holder onto the middle of the
1
controller's back until it engages.
The holder's length can be set with the
2
adjusting wheel. Fix the holder in such a
way that the tablet is firmly clamped onto
the controller.
Recharging the LiPo rechargeable
battery
Make sure you only charge the LiPo recharge-
able battery supplied with the LiPo charging
unit also supplied (USB cable and remote
control). If you try to charge the rechargeable
battery with a different LiPo battery charger
or any other battery charger, this might cause
serious damage. Please carefully read the
previous chapter with warnings and guide-
lines on the usage of rechargeable batteries
before proceeding. Supply terminals are not
to be short-circuited.
You can charge the rechargeable battery fit-
ted in the Quadrocopter with its USB charging
cable from a USB port on a computer:
Charging via computer:
4a
• Rechargeable batteries are to be re-
moved from the model before being
charged.
• Connect the USB charging cable with the
USB port of a computer. The LED on the USB
charger cable lights green indicating that the
charger unit is correctly connected to the com-
puter. If you plug in a Quadrocopter with a dis-
charged battery, the LED on the USB charg-
19
ENGLISH
Inhaltsverzeichnis
loading

Diese Anleitung auch für:

370503019

Inhaltsverzeichnis