probst TSZ-MAXI-800 Betriebsanleitung Seite 14

Installation
4 Installation
4.1 Mechanical attachment
Nur Original-Probst-Zubehör verwenden, im Zweifelsfall Rücksprache mit dem Hersteller halten.
The load capacity of the carrier/lifting device must not be exceeded by the load of the device,
the optional attachments (rotary motor, insert pocket, crane jib, etc.) and the additional load of
the gripped goods!
Grippers must always be suspended on a gimbal so that they can swing freely in any position.
Under no circumstances should the gripping devices be rigidly connected to the hoist/carrier!
This can lead to breakage of the suspension in a short time. This can result in death, extremely
serious injuries and damage to property!
When using the device on optional attachments (such as insertion pockets, crane jib etc.), it cannot be
ruled out that the device may collide with adjacent components due to the low design of the overall
device (to avoid loss of lifting height) if the device is suspended in an oscillating manner and
positioned unfavorably when the carrier device is moving.
This should be avoided as far as possible by positioning the appliance appropriately and adapting the
driving style.
Any resulting damage will not be covered by the warranty.
4.1.1 Lifting eye / Suspension bolt
The device is equipped with a lifting eye / suspension bolt and can be mounted on various carrier /
lifting devices.
Take care that the lifting eye / suspension bolt is safely joined with the lifting tackle (e.g. crane
hook, belt) and cannot slide down.
4.1.2 Load hooks and lifting tackle
The device is attached to the carrier/lifting device with a load hook or a suitable lifting tackle.
Ensure that the single chains strands are not twisted or knotted.
Attaching the device to the lifting device/carrier, take care that all local safety regulation is observed.
53100453-003 13 / 24 GB