Problem
The baby unit has no reception
Constant transmission
Constant range alarm
Parent unit permanently indicates low battery
status
Parent unit battery life is very short
Excessive static and interference
Range too small
Please retain your receipt, the user manual and item number.
Warranty claims or claims from promises of guarantee must be processed by the dealer. The technical specification, information and characteristics of the product de-
scribed herein have been compiled to the best of our knowledge and belief and are correct at the time of printing. Any information provided by reer should be correct
and authoritative. Nevertheless, reer does not accept liability for potential errors in this document and reserves the right to make changes to the product design and/or
specifications without prior notice. Reproduction and disclosure of information contained in this copyrightprotected document, in any form or by any means - graphical,
electronic or mechanical by photocopying, recording on tape or storage in a data retrieval system (even in part), require prior written consent from reer.
At the end of its life, this product must not be disposed of as normal domestic waste, but should be recycled at a collection point for electrical ap-
pliances. Please see the relevant symbol on the product, in the user manual and packaging. Materials can be recycled as specified. An important
contribution to the protection of the environment can be made by reusing the unit, recycling its components or otherwise reusing old appliances.
Please contact your local council to find out more about an appropriate disposal centre.
reer GmbH hereby declares that the radio system type in the Cosmo (Art.No.: 50150) complies with Directive 2014/53/EU.
All manuals and user guides at all-guides.com
Troubleshooting
Possible cause
•
Microphone sensitivity is too low
•
USB cable is not connected properly
•
Microphone sensitivity is too high
•
Continuous operation of the parent unit is activa-
ted without Auto-Off
•
Baby unit is switched off or no power supply
available
•
Distance between the units is too large
•
The coupling is faulty or no longer there
•
Built-in battery is empty
•
Battery is damaged
•
Vibration mode is switched on
•
Baby unit is near other electrical equipment
•
Excessive signal interference between the two
units
Environmental protection
Muehlstr. 41 • 71229 Leonberg • Germany
Operation permitted in the following countries:
DE,CH, AT, IT, FR, BE, NL, ES, LU, GR, HU, CZ, SI, PL, CY, DK, FI, IS, LI, LT, NO, RO, SE, SK, TR
The full EU Declaration of Conformity text is available at the following web address:
http://www.reer.de
Warranty
reer GmbH
www.reer.de
Action
•
Adjust the sensitivity with the Increase Microphone
Sensitivity button (11)
•
Check the power supply
•
Adjust the sensitivity with the Decrease Micropho-
ne Sensitivity button (11)
•
Switch on baby unit or test power supply
•
Reduce distance between units
•
Carry out coupling again
•
Charge the parent unit with the supplied charging
cable
•
Replace with new battery
•
Increase volume by pressing the button
•
Remove the other electrical equipment or reposi-
tion the baby unit
•
Reposition the parent and baby unit