VEVOR PZ-3240 Bedienungsanleitung Seite 16

The tool is controlled by one key, Press the trigger to start working; Piston comes
back automatically after finish pressing. Losing the trigger means stop forcing
pressure. Press retract button, piston fully comes back.
Warning:
1) This tool is a high-pressure, high-strength, heavy-duty appliance. Please
follow the instructions and precautions strictly to operate carefully!
2) Before operating, you must check the tool for any damage, aging, missing
parts, stuck components, and any other unfavorable factors that threaten
safety. If you find any problems, please stop using it immediately until the
problem is solved.
3) After pressing the jaw arm and holding the pipe, please keep your hands and
fingers away from the jaw, press the start button and hold it until the pressure
reaches the set value and reset automatically. Release the start button
halfway to pause, press the release button to return the piston.
4) Do not let the tool or jaws hang directly on the pipe fittings, to avoid
unnecessary injury or even fatal accidents caused by the tools falling
accidentally.
5) Before start the tool, the ram pin must be fully inserted into the ram, otherwise
it will easily cause damage to the ram and even personal injury.
6) Remove the grease from the non-lubricated parts of the tool, especially the
hand-held parts, to avoid the tool slipping during use.
7) Do not disassemble and assemble tools at will, otherwise tool damage or even
personal injury may occur.
8) Do not put your fingers and any part of the human body into the moving parts
of the jaws during use, and avoid pointing the tool head at yourself or others.
9) The pressure of the tool should be checked and calibrated regularly. The
pressure check and calibration need to be carried out under the special
pressure detection device. Do not adjust it without permission, otherwise the
tool may be damaged or even personal injury may occur.
Special suggestion:
- 15 -